PLUTO+ SDR Transceiver Radio 70MHz-6GHz Software Defined Radio For Gigabit Ethernet Micro SD Card

Production Description:

PLUTO+ is a software-defined radio platform that supports 2TX and 2RX, supports Gigabit Ethernet and Micro SD card. It refers to the design for well-known ADI ADALM-PLUTO and improves its shortcomings.

User Manual:

Our SDR technical engineers come from OpenSourceSDR Lab have writen the Pluto+ and GNU Radio relevant user manual. If you need it, you can contact our customer service staffs and let them send you the download link. And if you have any question when you use HackRF One (with portapack), you can feel free to contact us. We are very happy to disscuss SDR technology with you. You can contact our technical support engineer using telegram software via the link: https://t.me/OpenSourceSDRLab

To facilitate communication, please contact him and show your aliexpress  order ID to him.Welcome to join our telegram Group《OpenSourceSDR Lab》 via telegram software by the following link: https://t.me/joinchat/MrUQFRcNG0xjYTg1

Features:

- ADC/DAC: AD9363 (Can hack to AD9361 or AD9364)

- 2 Transmit, 2 Receiving channel

- RF Range: 70MHZ~6GHZ

- Ref Clock: VCTCXO 40MHZ 0.5ppm

- SOC: for Zynq7010 FPGA: 28k

- RAM: 512M

- FLASH: 32M

- USB: 2.0, support OTG

- Ethernet: 1000Mb

- Micro SD can use to boot

- DC IN: 5V±0.5V-2A microUSB

Interfaces:

Please note that all IO levels are 1.8V.

When using the official firmware for ADI-PlutoSDR, please connect to URST-MI052.

When using Pluto+ firmware and need to support Ethernet, please connect URST-MIO46

When using SD card to boot, please connect SD-H to 1V8

When using JTAG to debug, please connect JTAG# to GND

Please connect EXCLK to GND when using external reference clock input

PTT Key Port:

- PTT drives optocouplers through GPIO0 (MI00), which requires an external relay or control circuit.

DFU KEY:

-At any time, you can press the DFU button and power on PLUTO+ again to enter the DFU mode, but you need to connect the URST jumper to MI052.

Ref CLK input IPEX:

- You can connect a cable to input an external high-precision reference clock for AD9363 through the IPEX interface.

- The main level should not exceed 3.3V, and the EXCLK jumper needs to be connected to GND to turn off the built-in clock

Calibrate the Frequency of Built-in VCTCXO:

-The frequency of the 40M clock can be fine-tuned by adjusting the adjustable resistor next to the VCTCXO, provided that you have a reference signal source.

Micro-SD:

Support booting via SD card, need to connect SD-H jumper to 1V8.

Package List:

Bundle 1：

- 1 x SDR Radio PLUTO+

- 2 x MicroUSB cable

Bundle 2：

- 1 x SDR Radio PLUTO+

- 2 x MicroUSB cable

- 4 x 40MHz-6GHz telescopic antenna

Note:

- It is assembled and ready to use.

- SD card is not included in the package.